There was an error signing up for restock notifications. Please try again.
Cold Air Intake System
Fits all Emira V6 cars.
Includes all needed components for installation:
ITG High Flow Foam Filter with custom spec'd spun aluminum airbox (500hp rated)
Silicone airbox inlet coupler
Specially sized aluminum MAF housing with hardware in a powder coated finish
Specially made MAF to Throttle Body silicone coupler
Laser cut, powder coated airbox hanger bracket with rubber trim.
Cable ties for maf sensor harness
Appropriate clamps and hardware
Features:
These kits utilize the proper size air meter housing so no recalibration is needed, it is a simple bolt on and go type kit.
Uses a 500+hp rated semi sealed type airbox for optimum airflow and pulls air from the factory side inlet so you always have clean, ambient airflow.
Oiled type foam airfilter performs well even when dirty! They also provide much better airflow than the oem paper type filter or the aftermarket cotton gauze type.
Sheds weight! Stock airbox system is large and clunky, this new system is a clean simple design and weighs less than the oem system
The sound is awesome!! Wide open throttle and rev-matched downshifts sound particularly great with this system.
Improved throttle response
Dyno proven HP & TQ Increase! 12hp+ when installed along with our decat pipe and rear section exhaust.
Helpful install video below.
One small note not mentioned in the video --- There are four little slits on the top portion of the laser cut hanger bracket, those are for zip-tying the wire harness back up into position above the air canister to keep roughly the same routing as oem.
